Wire cutter 9 1/4 double-action straight, side cutting TC jaws, cuts up to 0.094(2.4mm)

Controlled Wire Cutting with Extended Reach

The Wire cutter 9 1/4" double-action straight is designed for cutting wire with side-cutting tungsten carbide jaws, supporting practical handling when reach and controlled jaw action matter. Its double-action configuration can help distribute hand input through the cutting mechanism, while the 9 1/4" length provides useful access around the operative field. The jaws are rated to cut wire up to 0.094" (2.4mm). This specialty-neutral design fits wire-cutting workflows across Cardiovascular, General Surgery, and Orthopedic settings, where dependable instrument handling and clear alignment with the work area are important.

Use Cases

• Cut wire up to 0.094" (2.4mm) using the side-cutting jaws.
• Use the 9 1/4" length when additional reach is useful within Cardiovascular workflows.
• Apply the straight cutter design to wire-cutting tasks in General Surgery settings.
• Support Orthopedic wire-management workflows requiring a double-action cutter.
• Use the tungsten carbide jaw construction as part of routine wire-cutting instrument selection.

Specifications

Care & Handling

• Clean the instrument according to facility procedures and the applicable manufacturer instructions for use.
• Inspect the side-cutting jaws, working surfaces, and double-action mechanism before and after use for damage, wear, or restricted movement.
• Handle the cutter by its intended grips and avoid using the jaws for tasks outside wire cutting.
• Store the instrument clean, dry, and protected from contact that could damage the cutting edges.

Specifications

General use; follow facility protocols.